/* */
loader

HESAI for Arduino UNO R3 Board + 3D Printer Cnc Shield V3 Engraver Machine Expansion Board + 4pcs A4988 Stepstick Stepper Motor Driver Module + Heat Sink

Note:

The Color Of A4988 Will Be Shipped In Random(green or red)

UNO R3 Board:

NEW IMPROVEMENT: Clearly print on the female header connector, more precise and easier to use the wire.

The Uno now uses an ATMega16U2 instead of the ATMega8U2 chip. Faster transfer rates and more memory.

Control using ATMEL ATMEGA328P chip

100% compatible with the official version

We have always cared about the customer experience and improve the product function details.

CNC Shield Board:

Each road stepper motors only need two IO ports.

This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.

It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.

Stepper motor wiring as follows: 2A, 2B is a group (red, green), 1A, 1B is a group (blue, yellow), if want to change direction, can be change the position of one group , for example 2A, 2B mutually exchanged.

PWM Spindle and direction pins. 4-Axis support. Runs on 12-36V DC.

A4988 Driver Module:

Simple step and direction control interface.

Five different step resolutions: full-step, half-step, quarter-step, eighth-step, and sixteenth-step. Output drive capacity of up to 35 V and ± 2 A.

Adjustable current control lets you set the maximum current output with a potentiometer.

Intelligent chopping control that automatically selects the correct current decay mode (fast decay or slow decay).

Over-temperature thermal shutdown, under-voltage lockout, and crossover-current protection.

Package List:

1x UNO R3 Board

1x USB Cable

1x CNC Board

4x A4988 Driver

4x Heat Sink

1x Screwdriver

Product Features

  • Each road stepper motors only need two IO ports
  • This expansion board as a driver expansion board, can be used for engraving machines, 3D printers.
  • It is a total of four slots, can drive four A4988 stepper motor. Each road stepper motors only need two IO ports. In other words, six IO ports can be well managed three stepper motors. Very convenient to use.
  • Stepper motor wiring as follows: 2A, 2B is a group (red, green), 1A, 1B is a group (blue, yellow), if want to change direction, can be change the position of one group , for example 2A, 2B mutually exchanged.
  • PWM Spindle and direction pins. 4-Axis support. Runs on 12-36V DC

Leave a Reply

Your email address will not be published. Required fields are marked *